Would it be possible to choose whether the oscilloscope display auto-scales (as it does now), or choose static scales. Maybe a selection of vertical volt or current scales?
The reason is that sometimes the way it auto scales as soon as a wave has passed can be unhelpful. For spot checks, autoscale is perfect. But for watching slow capacitor discharges, it can proved confusing.
Also.... how about a super simple spot check multimeter pointer which shows V and A at the end of a pointer. This could display briefly while touching a wire/component. Very small screen size.
Keep it up... it's going to get better and better. 👍
You could add an 'inspect' control (additional to the arrow, interactive and scope controls). This small inspection balloon pops up while pointer hovers over component or wire.
I was think of something like this...